OMSI 2 – Tricks, Strategies,Guide, Cheats, Tips and Secrets
Status Completed
Type Novel
Author GameguideeBooks
Posted By
Posted On
Updated On

OMSI 2 – Tricks, Strategies,Guide, Cheats, Tips and Secrets

Synopsis OMSI 2 – Tricks, Strategies,Guide, Cheats, Tips and Secrets


Cheat Codes:
Submitted by: David K.

Guidance for Ikarus:
Written by comradekiller72

-=Get started=-
* Jump into the driving seat
* Switch on the batteries * press E, or tap the right arrow button til you
  the dashboard. Make the steering
wheel disappear and click a black switch in
  the middle and the dashboard is
“alive” now.
* Press the red button near the key to start the engine. Depending on how
you set
  the maintenance level and weather
conditions, you need to apply throttle by Num8
  to make the Rába engine jump in.
Quick tip: you can shorten it by pre-heating the
  engine. In the passenger
compartment open the first lid on the floor. There is a
  valve for heating. Click on it. Go
back to the driver’s seat. There is a panel
  near the left leg of the driver.
The upper one controls the pre-heater and the
  circulating pump. Switch to the
upper position to ignite the heater and have the
  pump on. Wait until the coolant
temperature reach 40 Celsius and start.
  The engine jumps in
* Very tedious part, wait til the compressor fills up the pneumatic system.
It takes
  a couple minutes, because the two
brake circuits, the auxilary circuit for the
  doors, and the circuit for the air
springs need to be filled. Wait til the big
  red indicator is off or the bus
lifted up from the “kneeling”.

The bus has a manual transmission, 6 speeds.
* Start from second gear, the first gear is needed at hill start only
* Shift up at 1800 rpm at flat ground, when you go uphill, 2100 rpm.
* Cruising speed is at 1500 rpm, so the Citybus series has 50km/h at that
  the Regiobus has 60km/h.
* The motor brake works by the “K” key in default. It has a very distincive
sound –
  the hungarian slang for it is

-=How to shut the engine down:
* Switch to neutral, and press the “K” key. It shuts the engine down.
* When the air pressure is not sufficient enough, you have to stall the
* Press the Tab key + any number key from 1 to 6, the release the Tab

* Open the valve under the first lid on the floor
* Near the driver’s left leg there are two panels. The upper one controls
  “Thermal” heating. Flip the switch
to the upper position for pre-heat the engine
  and turn the circulating pump on.
When the engine is warm – 80 degrees Celsius –
  flip the switch down for the
circulating pump only.
* The seond panel controls the dry-air heater. The closer switch to you
  the heater, up position is heater,
middle is off, down is ventilation.
  The fartest one controls the

Chapter OMSI 2 – Tricks, Strategies,Guide, Cheats, Tips and Secrets


Bir cevap yazın

E-posta hesabınız yayımlanmayacak. Gerekli alanlar * ile işaretlenmişlerdir